Module 3.1: The Arduino Command Line

In Module 3.1, we discuss why we’re using the command line, and install the Arduino Command Line library written by us at Freaklabs. Once that’s installed, we go through our hands-on labs where we write code to implement the command line directly on the WildLogger board. We also implement a table of custom commands which allows us to control the WildLogger in real time, in this case, changing the speed of a blinking LED.

Click here for video slides, terminology, downloads and additional references

 

3.1.1  The Arduino Command Line – Lab 1

In this video we cover

Module 3.1.1: The Arduino Command Line – Lab 1 (PDF)

 

 

3.1.2 Setting and Accessing Parameters – Lab 2

In this video we cover

3.1.2: Setting and Accessing Parameters – Lab 2 (PDF)

 

 

3.1.3 Changing Parameters in Real Time – Lab 3

In this video we cover

3.1.3: Changing Parameters in Real Time – Lab 3 (PDF)

 

 

Supporting Materials

Terminology Sheet

Module 3.1 Terminology Cheatsheet (PDF)

 

Video Slides

3.1.1: The Arduino Command Line – Lab 1 (PDF)

3.1.2: Setting and Accessing Parameters – Lab 2 (PDF)

3.1.3: Changing Parameters in Real Time – Lab 3 (PDF)

 

Conversations & Troubleshooting

Module 3.1 Discussion (forum thread)

 


Copy link