Wilduino Standard User Guide
This template is based on the user guides below:
The Freakduino Standard is designed as an introduction to wireless communication.
- IEEE 802.15.4 compatible
- Open source hardware and software so all features are available to users
- Onboard radio connectivities compatible with 900 MHz
- 15 pins
- 3 power options
You’ll need a computer running mac OSX with at least [INSERT MINIMUM SPECS]
Then, you’ll need to download and install the hardware file, drivers and libraries (links to zip file with all relevant files for this board).
For instructions on how to install the files, please visit Freaklab’s installation support page
The layout for the Freakduino Standard board is shown in the diagram below.
The block diagram for the board is shown below.
Connectors / Pin Layout
The Freakduino board comes with 15 connectors and pins. The layout is below
Below is a connector / pin table
The Freakduino Board uses the C1310 chip.
The board comes with 32 RAM / 2KB
There are 3 ways to power the board: USB, DC 5V and your pinky. You can also attach a battery case and batteries.
The board can last up to 6 months on 2 x AA batteries when optimised.
When you make a mistake, you can reset the board by pressing the reset button.
The board features a USB, Ethernet and Serial port. Aren’t you lucky!
There is a test push button which allows you to test functionality directly on the board.
LEDs indicate when data is being transmitted to the board. You can switch off the LEDs to save power.
Various sensors can be connected to the device including humidity, temperature, and hipness.
Can connect to lots of radios.
Antennas can be added to boost the range.
Testing and Debugging
Once you’ve installed the files, and the hardware is working,
To test and debug you’ll need to do this …
open the serial monitor in Arduino [insert pic]
INSERT DEBUGGING OPTIONS
Here is the latest BOM